applets.

Ripple Tank

← All apps

About Ripple Tank

A ripple tank is a shallow glass tray of water with a lamp above it and white paper below. Each crest of a wave bulges up like a long thin lens and gathers the lamp's light into a bright line on the paper; each trough spreads it out into a darker band. So the paper shows every wave as a moving line of light, and you can watch waves do everything light does, slowly enough to see. This page is that tank: 45 cm by 30 cm of water, seen as the lit paper through the tank's frame.

Scenes set the tank up for one experiment and start it from calm water, so you watch the pattern build. Each has one setting of its own under the sliders (a gap's width, a wall's angle, the moving dipper's speed). Frequency is how many times a second the motor dips; Wave speed how fast waves cross the deep water; the wavelength is the speed divided by the frequency. Shallow water sets how fast waves go over the plastic plates that make water shallow (shown tinted). Damping is how quickly the water calms down.

Tools: draw your own walls (WALL), lay shallow plates (SHALLOW), rub either out (ERASE), add or move round dippers (DIPPER, which also removes one if you click it without dragging) and measure with a steel rule (RULE, which gives the length in centimetres and in wavelengths). EMPTY TANK takes everything out. Your own drawing isn't put in the link; the scene and settings are.

RUN runs the water (PAUSE stops it, RESUME carries on), STEP moves it on an eighth of a wave, CLEAR WAVES calms it. The speed buttons slow everything down (¼ is a quarter of real speed). The strobe does what a real tank's strobe does: FREEZE flashes the lamp once every dip, so a steady pattern stands still; CREEP flashes a little less often, so the waves seem to crawl slowly forward. Show Expected draws, in blue pencil, where the textbook formulas put the calm lines, the bent or reflected direction, or the focus. Keys: Space plays and pauses, S steps, C clears the waves, L changes the strobe.

THE STORY

Thomas Young, a London physician, argued from 1801 that light is a wave, using the way two sets of waves can cancel. He showed it with light through two narrow openings, the experiment now known as Young's double slit, in lectures and papers between 1801 and 1804. In his Course of Lectures on Natural Philosophy (1807) he drew two sets of circular waves crossing, with calm lines running out between them, and compared them with waves on water. The calm lines are where a crest from one source always meets a trough from the other.

Other pieces in the tank: Willebrord Snellius's law of refraction (1621; the Persian mathematician Ibn Sahl had written it down in 984), Christian Doppler's 1842 paper on how a moving source changes the waves it sends out, and the V-shaped wave behind anything moving faster than its waves, the same shape as a boat's bow wave and, in air, a supersonic shock.

Ripple tanks became a fixture of school physics with the American PSSC course of the late 1950s and Britain's Nuffield Physics in the 1960s. A pupil would freeze the pattern by looking at it through a hand stroboscope, a disc with slots spun by hand, or the tank would have a flashing lamp.

HOW IT WORKS

The water is a grid of 360 by 240 squares, each 1.25 mm across, holding the height of the surface. Every step, each square's height moves on by how far it moved last step plus how much it is pulled towards its four neighbours (the wave equation, stepped by the leapfrog method). The step is small enough to keep the sums stable: for this grid a wave may cross at most 1/√2 of a square per step (the Courant, Friedrichs and Lewy limit of 1928); the page uses half a square at the fastest speed, and fits a whole number of steps into each dip, so the strobe catches the same moment every time.

Walls are squares with no water: no water flows into them, so a crest comes back off a wall as a crest, as on real water. Shallow squares just have a lower speed. Round the tank, out of sight, is an 8 cm beach where the waves are gently damped, and at its far edge a rule that lets a wave pass straight out (Mur, 1981), so the sides send back only a few per cent. A dipper adds a little up-and-down to the water each step; waves pass back through it. The bright lines are drawn from the height: the higher the water, the brighter the paper.

What it leaves out. The waves are small, so heights simply add. Real ripples of a centimetre or two are partly held up by surface tension, so their speed depends on their wavelength as well as the depth; here each depth has one speed. Waves shorter than about eight squares travel a little slowly on the grid, more along the grid lines than across them. The beach is good but not perfect, mostly for the longest waves. Damping is one rate everywhere. The lamp's light isn't traced through the water. The lens's Expected focus uses the thin-lens sum, which ignores the plate's thickness and the way waves of a few centimetres blur a focus, so the brightest spot usually sits a little nearer the lens. The tests behind the page check the measured speed and wavelength against the settings, Young's fringes and Doppler's wavelengths against their formulas, the stability limit, and that a wall sends a crest back as a crest.

FURTHER WATCHING AND READING

SPEED
STROBE
TIME