applets.

Landing Beams

← All apps

About Landing Beams

An airliner can find a runway it cannot see, and in the right conditions land on it by itself, using two radio beams from the ground: the instrument landing system, ILS. This bench shows how the beams work, lets you fly an approach down into fog, and shows the older beacons pilots take bearings from. It is a teaching model: never use it for navigation.

THE BEAMS: the localiser (the beam that lines you up with the runway) and the glide path (the beam that brings you down a slope, usually 3 degrees; a few airports need steeper ones) each send two overlapping lobes. One carries a 90 Hz tone, the other a 150 Hz tone. Drag the little aircraft through the plan view and the side view: the meters show how strongly each tone is heard and the needles show the difference. The colours show which tone wins everywhere: blue where 90 Hz is louder, amber where 150 Hz is. The presets take you to the places worth seeing, including the false glide paths far above the real one.

FLY THE APPROACH: start 8 nautical miles out, below the glide path and left of the centre line, and press FLY. Fly it yourself (the arrow keys or the four buttons turn and change your rate of descent; tick Invert ▲ ▼ to have ▲ put the nose down, as pushing a control column forward does) or let the autopilot do it: it steers by the two needles alone, using the radio altimeter only for the flare from 50 ft. The four buttons light while they are being used, by your keys or by the autopilot as it makes its corrections. Choose the category of approach (it sets the decision height), the fog, a crosswind, and whether a taxiing aircraft is in the localiser's critical area. At decision height the page waits for your call: LAND if you can see the lights and the needles are central, GO AROUND if not. The steps tick off as you pass them.

BEACONS: an NDB (a plain radio beacon on long and medium waves) and a VOR with DME. Drag the aircraft or the storm on the map, change your heading and height. The radio magnetic indicator's thin needle points at the NDB, the thick one at the VOR. Tick NIGHT or THUNDERSTORM and press WATCH THE NEEDLE to see why pilots never trusted an NDB needle on its own.

THE STORY

On 24 September 1929 Jimmy Doolittle took off, flew a short circuit and landed at Mitchel Field, New York, under a hood, seeing nothing outside, using new gyro instruments and radio beacons. In the 1930s the German firm C. Lorenz AG sold a blind-approach beam: two overlapping lobes, one keyed with Morse dots, the other with dashes. Off to the left the pilot heard dots, off to the right dashes, and on the centre line the dots filled the gaps in the dashes and made one steady tone, the equisignal. The ILS keeps the same idea but replaces the listening with two tones and a needle.

In the late 1930s the Luftwaffe turned the Lorenz idea into a bombing aid, Knickebein ("crooked leg"), first used against Britain in 1940: bombers flew along one sharp beam until a second beam crossed it over the target. R. V. Jones of Air Ministry intelligence worked out what it was, an RAF aircraft carrying a receiver found the beams over England, and jammers code-named Aspirin sent extra dots so that crews could no longer find the centre. This "Battle of the Beams" ran through 1940 and 1941, with new German systems and new British answers. The Germans came to believe the British could bend their beams; they could not, they only confused them.

After the war the ILS became the international standard for landing in bad weather. On 10 June 1965 a British European Airways Trident landed automatically at Heathrow at the end of a scheduled flight from Paris, the first automatic landing in passenger service (in fair weather; landings in real fog with passengers followed). Today big airports in fog run on Category III approaches flown by the autopilot. Satellite approaches are taking over many jobs, and the older beacons are going: the UK plans to cut its network of VORs run by NATS from 46 to 19 in stages, and approval has been given to remove all its en-route NDBs.

HOW IT WORKS

Difference in depth of modulation. Both tones ride on one carrier. On the localiser each tone modulates it by 20% on the centre line; on the glide path by 40%. Off the line one gets deeper and the other shallower, and the receiver measures only the difference (the DDM). It does not need to know how strong the signal is or how far away the transmitter is. Seen from an approaching aircraft, 90 Hz wins on the left of the localiser and above the glide path, 150 Hz on the right and below. The needles point to where the beam is: fly towards the needle.

The sizes follow ICAO Annex 10: the localiser gives 0.00145 DDM per metre at the ILS reference datum (50 ft over the threshold), so its course sector (DDM 0.155) is about 107 m either side there; the glide path gives a DDM of 0.0875 at 0.12 of its angle above or below. In this page the needles reach the edge of the dial at 0.155 (localiser) and 0.175 (glide path), with dots at half way. Localisers use 40 channels between 108.10 and 111.95 MHz (VHF), each paired with a glide path channel between 329.15 and 335.00 MHz (UHF), so the pilot tunes only one: this bench uses 109.50 with 332.60. The localiser sits beyond the far end of the runway, the glide path aerial beside the runway about 300 m in, so the 3 degree slope crosses the threshold at about 50 ft. A 3 degree slope falls about 318 ft for every nautical mile.

The false glide paths. The glide path aerials use the ground in front of them as a mirror. In the common "null reference" design, one aerial sends the carrier with both tones and another, twice as high, sends only the difference between the tones. The mirror gives the second aerial's pattern nulls at about 1, 2, 3 and more times the path angle, and the first aerial's nulls at 2 and 4 times. So above the real 3 degree path the needle centres again near 9 degrees, working backwards (fly up when you are already too high), and near 6 and 12 degrees the signal fades and the receiver shows its flag. Real aerials and ground vary: published guidance says reversals usually appear near 9 degrees, false nulls near 12 and either near 6. Pilots avoid them by joining the glide path from below, and incidents still happen when an autopilot grabs a false one from above.

Marker beacons on 75 MHz point a narrow fan straight up. The outer marker (blue lamp, 400 Hz dashes, two a second) sits a few miles out, here at 4 nm; the middle marker (amber, 1,300 Hz dots and dashes in turn) at about 1,050 m; the inner marker (white, 3,000 Hz dots, six a second) close to the threshold where one is installed. Many airports now use DME distances instead.

Categories. The page uses the classic ICAO table (as it stood before 2022): CAT I has a decision height of 200 ft or more and a runway visual range (RVR) of at least 550 m; CAT II a decision height between 100 and 200 ft and at least 300 m; CAT IIIA below 100 ft (or none) and at least 175 m; CAT IIIB below 50 ft (or none) and down to 50 m. Since 2022 ICAO (which now classes approaches as Type A and B) and EASA have merged IIIA and IIIB into one CAT III: a decision height below 100 ft or none, and an RVR below 300 m. EASA's lowest figures are 175 m with a decision height of 50 to 99 ft and 75 m with none (or below 50 ft) for fail-operational autoland; the page uses those two for IIIA and IIIB. CAT II and III need special aircraft, crews and airport procedures, and in Europe an approach may not normally be continued past a set point if the reported RVR is below the minimum.

The NDB sends a plain carrier with a Morse identifier somewhere between 190 and 1750 kHz; the aircraft's direction finder (ADF) works out where it comes from (early sets turned a loop aerial by hand or motor; modern ones use fixed crossed loops and a sense aerial). Ground waves at those frequencies are spoiled by the sky wave at dusk and at night (the needle wanders, worse the further away you are), by lightning (the needle swings towards the storm) and by the coast (where the signal crosses the shore at a shallow angle it bends, and the bearing comes out a few degrees wrong). The VOR (108.00 to 117.95 MHz) sends two 30 Hz signals: a reference that is the same in every direction (frequency modulated on a 9,960 Hz subcarrier) and a variable one from a rotating pattern whose phase changes with direction. The phase difference, in degrees, is your bearing from the station, the radial. In a Doppler VOR (all of NATS's UK VORs are this kind) the two roles swap, the 30 Hz amplitude modulation being the reference, but the receiver reads them the same way. DME works like secondary radar: the aircraft sends pairs of pulses, the ground station replies after a fixed delay (50 microseconds on X channels, as here; 56 on Y channels), and the time there and back gives the distance, 12.36 microseconds for each nautical mile. It is the slant range, so overhead at 30,000 ft it still reads about 4.9 nm.

WHERE THE PAGE SIMPLIFIES

The glide path is the ideal null reference pattern over perfectly flat ground, and the localiser is a smooth curve with the ICAO sensitivity rather than a real array of many aerials. The plan and side views draw sideways distances and heights 5 times bigger than along-track distances so the narrow beams can be seen (the angles on the labels are the real ones). The aircraft flies at a steady 140 knots with simple turns and climbs, there is no turbulence, no terrain, and the ground is level with the runway. The autopilot uses only the needles, the radio altimeter for the flare, and its distance from the aerials (real ones change their gains as the approach goes on). The fog is uniform; real fog comes in patches and the RVR is measured along the runway. The sizes of the NDB errors and the taxiing aircraft's bend in the localiser are illustrative, not measured. North on the map is magnetic north.

FURTHER WATCHING AND READING

An airliner can land itself in thick fog guided by two radio beams (and a radio altimeter for the last few feet). The needles ask one question: which tone is louder, 90 Hz or 150 Hz? Drag the aircraft or click anywhere in the views.Drag the aircraft or tap anywhere in the views.

PLAN VIEW · LOCALISER 109.50 MHz 
SIDE VIEW · GLIDE PATH 332.60 MHz 
90 Hz louder150 Hz loudersignal too weak Sideways distances and heights drawn 5 times bigger; side view stops at 13.5°
Localiser 
90 Hz 
150 Hz 
Glide path 
90 Hz 
150 Hz 
Go to
TEST CARD 

The needle doesn't depend on how strong the signal is (the receiver checks the strength only to decide whether to show a flag). It subtracts one tone's depth from the other's (the DDM) and moves the needle by the difference, so a near beam and a far one read the same on the line.